{"id":5368,"date":"2026-11-11T18:28:55","date_gmt":"2026-11-12T02:28:55","guid":{"rendered":"https:\/\/www.26yc.com\/pre-filter-change-on-delta-p\/"},"modified":"2026-11-11T18:28:55","modified_gmt":"2026-11-12T02:28:55","slug":"pre-filter-change-on-delta-p","status":"publish","type":"post","link":"https:\/\/www.26yc.com\/ja\/pre-filter-change-on-delta-p\/","title":{"rendered":"Change the Pre-Filter on Pressure Drop, Not on the Calendar"},"content":{"rendered":"<h1>Change the Pre-Filter on Pressure Drop, Not on the Calendar<\/h1>\n<p>A maintenance contract said &#8220;replace G4 panels every three months&#8221;. The paint shop ran two shifts in winter and one in summer. In July the panels came out almost clean; in February they were loaded solid for six weeks. Nobody had done anything wrong. The schedule was simply written for an average site that does not exist.<\/p>\n<h2>The small number, and the large one<\/h2>\n<p>Take a 12,000 m3\/h make-up air unit (3.33 m3\/s) with a G4 panel starting at 45 Pa and a change-out setpoint of 120 Pa. Average differential over the loading cycle is about 82.5 Pa. At 62% fan efficiency:<\/p>\n<ul>\n<li>Average fan power for the filter: 3.33 x 82.5 \/ 0.62 = <strong>443 W<\/strong>.<\/li>\n<li>If someone budgets against the clean 45 Pa figure: 3.33 x 45 \/ 0.62 = <strong>242 W<\/strong>.<\/li>\n<li>Difference: 201 W x 6,000 h = <strong>1,206 kWh\/year<\/strong>, about \u20ac145 at \u20ac0.12\/kWh.<\/li>\n<\/ul>\n<p>That is a small number, and we tell clients that to their face. If the only saving were \u20ac145, we would not write an article about it.<\/p>\n<p>The real cost is downstream. A loaded or badly seated pre-filter lets dust through to the recovery core. On a paint booth or an oven exhaust that means a foil channel cleaning every six months instead of every two years: say \u20ac900 for a strip-down and chemical wash, plus four hours of lost production, twice a year. The filter itself costs \u20ac18. The <a href=\"\/ja\/plate-heat-exchanger-cleaning-maintenance\/\">plate exchanger cleaning guide<\/a> shows what that strip-down involves; the <a href=\"\/ja\/mine-ventilation-heat-recovery\/\">mine ventilation case<\/a> is the extreme version, where frost and dust combine.<\/p>\n<figure><img decoding=\"async\" src=\"https:\/\/www.26yc.com\/wp-content\/uploads\/2026\/11\/pre-filter-change-on-delta-p.svg\" alt=\"Filter pressure drop rising over a loading cycle with a 120 Pa change-out setpoint, plus downstream core cleaning cost\" style=\"max-width:100%;height:auto;border:1px solid #e6ebef;border-radius:8px;\" \/><figcaption>The \u20ac18 part protects the \u20ac9,000 part. Budget the second number.<\/figcaption><\/figure>\n<h2>How we set the change-out point<\/h2>\n<p>Not from a catalogue. We put a differential pressure transmitter across the filter bank, log it for a few weeks, and set the alarm at the pressure where the fan can no longer hold design airflow \u2014 or earlier, if the downstream core is sensitive. For a G4 panel on a general AHU that is often 100\u2013150 Pa; for a coarse panel ahead of a compact plate core we set it lower. The <a href=\"\/ja\/air-filter-maintenance-replacement-pressure-drop\/\">filter maintenance guide<\/a> walks through the measurement setup, and <a href=\"\/ja\/heat-exchanger-pressure-drop\/\">pressure drop and fan energy<\/a> explains why the fan curve, not the filter datasheet, should decide the limit.<\/p>\n<p>Two details from the sites where this went badly:<\/p>\n<ul>\n<li><strong>The frame, not the media.<\/strong> A new panel clipped into a warped holding frame bypasses around the edge. Measure across the whole bank, not across one panel.<\/li>\n<li><strong>Seasonal setpoints.<\/strong> In a cold climate, a loaded pre-filter reduces supply airflow exactly when frost risk on the exhaust face is highest. Our <a href=\"\/ja\/frost-protection-heat-recovery\/\">\u9632\u971c\u30ac\u30a4\u30c9<\/a> \u3068 <a href=\"\/ja\/rotary-wheel-frost-defrost\/\">wheel defrost strategies<\/a> assume design airflow; they do not hold when the filter is blinded.<\/li>\n<\/ul>\n<h2>What belongs in the specification<\/h2>\n<p>Three lines: an initial pressure drop at rated airflow, a change-out differential with an alarm, and a requirement that the filter bank be sealed and measurable. Then add the monitoring point to the BMS handover. A calendar interval can stay in the maintenance manual as a backstop, but it should never be the control.<\/p>\n<p>For the grade of pre-filter itself \u2014 panel, pocket, washable, G1 to G4 \u2014 see <a href=\"\/ja\/primary-filters-g1-g4-panel-pocket-specifications\/\">primary pre-filter selection<\/a>\u3001\u304a\u3088\u3073 <a href=\"\/ja\/primary-vs-medium-vs-high-efficiency-filters-comparison\/\">the three-stage comparison<\/a> if you are deciding what sits behind it.<\/p>","protected":false},"excerpt":{"rendered":"<p>The 18 EUR part protects the 9,000 EUR part.<\/p>","protected":false},"author":0,"featured_media":0,"comment_status":"closed","ping_status":"closed","sticky":false,"template":"","format":"standard","meta":{"footnotes":""},"categories":[356],"tags":[],"class_list":["post-5368","post","type-post","status-publish","format-standard","hentry","category-primary-filters"],"_links":{"self":[{"href":"https:\/\/www.26yc.com\/ja\/wp-json\/wp\/v2\/posts\/5368","targetHints":{"allow":["GET"]}}],"collection":[{"href":"https:\/\/www.26yc.com\/ja\/wp-json\/wp\/v2\/posts"}],"about":[{"href":"https:\/\/www.26yc.com\/ja\/wp-json\/wp\/v2\/types\/post"}],"replies":[{"embeddable":true,"href":"https:\/\/www.26yc.com\/ja\/wp-json\/wp\/v2\/comments?post=5368"}],"version-history":[{"count":0,"href":"https:\/\/www.26yc.com\/ja\/wp-json\/wp\/v2\/posts\/5368\/revisions"}],"wp:attachment":[{"href":"https:\/\/www.26yc.com\/ja\/wp-json\/wp\/v2\/media?parent=5368"}],"wp:term":[{"taxonomy":"category","embeddable":true,"href":"https:\/\/www.26yc.com\/ja\/wp-json\/wp\/v2\/categories?post=5368"},{"taxonomy":"post_tag","embeddable":true,"href":"https:\/\/www.26yc.com\/ja\/wp-json\/wp\/v2\/tags?post=5368"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}