From air to liquid
As rack densities climb, air cooling hits its limit. Liquid cooling – cold plates, rear-door coolers, or immersion – captures server heat directly in water, at 30-50C. That warm water is a prime recovery stream.
What you recover
- Facility heating – warm loops heat offices or adjacent buildings via air-to-water recovery.
- District feed – excess heat exports to a district energy station.
- CHP synergy – pair with CHP for a resilient low-carbon loop.
Why it beats air-side only
Liquid capture reaches higher temperatures than air-to-air, enabling more reuse. It also lowers PUE by removing fan-heavy air transport. Start from our data-center heat recovery overview and measure with efficiency metrics.
Retorno de inversión
Reusing server heat for district or process loads can cut a data center’s net energy cost 10-30%. Validate with a payback calculation.
The temperature advantage of liquid
Liquid cooling captures server heat at 30 to 50C directly in water, warmer than air-side recovery can reach and therefore useful for more applications: facility heating, adjacent buildings, or export to a district network. Higher source temperature also means any heat pump used to uplift it runs at a better COP than if it started from cool exhaust air. The liquid loop is the natural backbone of data-center recovery.
From server to useful load
The captured warm water can serve on-site heating, feed a district energy station, or pair with CHP for a resilient low-carbon loop. Where the temperature or demand does not line up directly, a heat pump bridges the gap, and the efficiency metrics from commissioning show how much of the server load is actually reused versus rejected.
Controls and scaling
Recovery should follow IT load, which fluctuates with utilization, so the control must match heat capture to real-time demand and avoid stranding heat with no sink. As rack densities rise, liquid capture scales better than air-side methods and continues to lower PUE by removing fan-heavy air transport. Start from the data-center overview and measure with efficiency metrics before committing capital.
Preguntas frecuentes
Why move from air to liquid cooling recovery?
Liquid captures server heat at 30 to 50C, warmer than air-side recovery, enabling more reuse and a lower PUE.
What can the recovered heat do?
It can serve facility or adjacent building heating, export to a district energy station, or pair with CHP for a low-carbon loop.
How does it beat air-side only?
It reaches higher temperatures for better heat-pump COP and removes fan-heavy air transport from the cooling path.
What savings are typical?
Reusing server heat can cut a data center net energy cost by 10 to 30 percent. Validate with a payback calculation.
Preguntas frecuentes
Why move from air to liquid cooling recovery?
Liquid captures server heat at 30 to 50C, warmer than air-side recovery, enabling more reuse and a lower PUE.
What can the recovered heat do?
It can serve facility or adjacent building heating, export to a district energy station, or pair with CHP for a low-carbon loop.
How does it beat air-side only?
It reaches higher temperatures for better heat-pump COP and removes fan-heavy air transport from the cooling path.
What savings are typical?
Reusing server heat can cut a data center net energy cost by 10 to 30 percent. Validate with a payback calculation.
Especifique el intercambiador adecuado
Nuestros ingenieros dimensionan el núcleo según su caudal, temperatura y presupuesto de caída de presión, y seleccionan recuperación por placa, rotativa o caloduc según la aplicación. Lea la guía del intercambiador , o contáctenos para una especificación.
Productos relacionados
Recuperación por placa, rotativa o caloduc para HVAC y ventilación.
Núcleos estacionarios de gran superficie para aire y líquido.
Recuperación de energía de alta eficacia para grandes caudales.
Corrientes pasivas y totalmente separadas para aplicaciones limpias.