A rotary energy wheel is exceptionally effective at recovery, but in cold climates that same effectiveness becomes its weak point: the wheel constantly rotates the cold supply side through the warm, moisture-laden exhaust, and below freezing the exhaust condensate freezes onto the matrix and can block the duct. Understanding why wheels frost and how to […]
Comment fonctionnent les échangeurs à caloducs : récupération passive sans pièce mobile
A heat-pipe heat exchanger is the quiet workhorse of air-to-air recovery: it moves heat from one airstream to another with no fan, no pump and no moving parts inside the core, relying entirely on the physics of a two-phase refrigerant loop. That makes it uniquely suited to dirty, greasy or contamination-sensitive exhaust where you want […]
Récupération de chaleur pour blanchisserie commerciale : captage de l'extraction de sécheuse et laveuse
A commercial laundry is a relentless consumer of energy: washers fill with hot water that goes down the drain, and dryers exhaust hot, moist, lint-laden air that must be replaced by conditioned make-up air. In a 24/7 operation like a hotel, hospital or uniform service, that load dominates the utility bill, which makes laundry one […]
Pool Dehumidification & Heat Recovery
A natatorium is one of the toughest HVAC environments in any building: warm water evaporates continuously, loading the air with vapour that condenses on every cold surface and rots the structure if ignored. Ventilation must remove moisture, not just heat, and the make-up air it pulls in is expensive to condition. The right air-to-air recovery […]
ERV pour salles de classe : réduire l'énergie CVC dans les écoles sans sacrifier la QAI
Cramped classrooms with 30 students can blow past 1,000 ppm CO2 within an hour of occupancy if ventilation is weak, and ASHRAE 62.1 sets a minimum outdoor-air rate that, met with simple make-up air, dumps expensive conditioned energy straight out the window in winter. An energy recovery ventilator (ERV) or heat recovery ventilator (HRV) breaks […]
Cross-Flow vs Counter-Flow Heat Exchangers
When specifying a plate air-to-air heat exchanger, the flow arrangement — how the supply and exhaust airstreams meet inside the core — is the single biggest determinant of peak effectiveness and of how the core packages into your unit. Cross-flow (streams perpendicular) and counter-flow (streams opposite) are the two common arrangements, with parallel-flow rarely used […]
Recuperation de chaleur en serre : recycler l'echappement chaud pour reduire les factures de chauffage
Cold-climate growers face a brutal conflict: crops need high air changes to control humidity and CO2, but every air change in winter throws away the expensive heat used to keep the house warm. In a grow facility the heating bill is often the largest operating cost, so recovering energy from the exhaust is one of […]
Récupération de chaleur pour blocs opératoires et chambres d'isolement hospitaliers
Hospitals ventilate harder than almost any other building type, and operating theatres and isolation wards sit at the extreme end: 20+ air changes per hour of conditioned air, strict directional pressure relationships, and zero tolerance for contaminated air reaching patients or staff. That intensity makes recovery valuable but also constrains it. This article covers where […]
Cleanroom Make-Up Air Recovery: GEP & ASHRAE 90.1
Pharmaceutical cleanrooms condition enormous volumes of 100% outdoor air to hold tight temperature, humidity and particulate limits, and that make-up air is the single largest controllable energy drain in a GMP facility. A properly specified air-to-air heat recovery core can hand back 60–75% of the sensible energy in the exhaust before it is thrown away, […]
Pharma & Hospital Heat Recovery: Zero Cross-Leak
How to specify heat recovery for pharmaceutical cleanrooms and hospital isolation rooms where cross-contamination is unacceptable. Plate, heat pipe, and run-around coil compared.