A high-temperature heat pump (HTHP) upgrades low-grade waste heat to useful process temperatures of 80 to 120°C, replacing steam boilers or direct electric heaters in industry. This article covers selection and integration.
How It Differs from a Standard Pump
An HTHP uses refrigerants and compression ratios tuned for high lift. The trade-off is lower COP as delivery temperature rises — plan the duty with the heat pump selection calculation 方法。
典型应用
- 工艺热水与 CIP 回路。
- 低压蒸汽发生。
- 干燥与蒸发中的预热，配合 工业废热回收案例.
Performance Targets
| 输出温度 | 典型 COP |
|---|---|
| 60°C | 4.0–5.0 |
| 90°C | 3.0–3.8 |
| 120°C | 2.0–2.8 |
Integration Tips
使废热源温度高于最低进水温度，并按实际工艺流量设计热汇。更宏观的回收背景请参阅 热泵废热回收. An HTHP is the bridge that turns “too-cold-to-use” reject heat into saleable process energy.
Siting and Controls
An HTHP earns its keep only when a genuine high-temperature use exists, process hot water, low-pressure steam, or drying preheat, and when a steady low-grade source is available to feed it. Place the evaporator as close as practical to that source to limit pumping losses, and size the sink for the real process flow rather than a peak, since oversizing the high-lift compressor is expensive. Controls should prioritize the recovery duty: run the HTHP whenever the waste-heat source and the process demand coincide, and let a buffer tank bridge short mismatches. Refrigerant choice and discharge-temperature limit matter more here than in a comfort pump, so confirm the working fluid can reach the needed delivery temperature safely. Where the process can accept a lower supply temperature, doing so lifts COP materially, so negotiating the process setpoint downward is often the cheapest performance gain.
常见问题
What temperatures can a high-temperature heat pump deliver?
Typically 80 to 120 degrees C, replacing steam boilers or direct electric heaters in suitable industrial processes.
Why does COP fall as delivery temperature rises?
Higher lift requires higher compression ratios, so more work is needed per unit of heat delivered.
What is the ideal source for an HTHP?
A steady low-grade waste-heat stream such as exhaust, wastewater, or process reject, above the minimum entering temperature.
How can HTHP performance be improved without new hardware?
Lowering the required process supply temperature, where the process allows, raises COP significantly.
常见问题
What temperatures can a high-temperature heat pump deliver?
Typically 80 to 120 degrees C, replacing steam boilers or direct electric heaters in suitable industrial processes.
Why does COP fall as delivery temperature rises?
Higher lift requires higher compression ratios, so more work is needed per unit of heat delivered.
What is the ideal source for an HTHP?
A steady low-grade waste-heat stream such as exhaust, wastewater, or process reject, above the minimum entering temperature.
How can HTHP performance be improved without new hardware?
Lowering the required process supply temperature, where the process allows, raises COP significantly.
相关产品
面向暖通空调与通风的板式、旋转式或热管回收。
空气与液体用大表面积固定芯体。
大风量用高效能量回收。
用于洁净场合的被动、完全分离气流。