For years “Made in China” meant low-cost copies. In heat exchangers that story is ending. Industry reports put Chinese applicants at roughly 38–41% of global heat-exchanger patent filings in 2025 — behind only the combined EU/US lead on fundamental heat-transfer theory, but ahead on volume. Where the patents are going Microchannel aluminium cores for EV […]
Tunnel Ventilation Heat Recovery
Tunnels and underground spaces move enormous volumes of air, and the ventilation fans are among the largest energy consumers on the whole facility. Jet fans push air along the tunnel, supply and exhaust fans replace it, and in a cold-climate region the incoming air is heated before it enters so it does not freeze the […]
Wastewater Plant Heat Recovery
A wastewater treatment plant is a surprising place to find a heat-recovery opportunity, but it is one of the best. Digester gas burns to keep anaerobic digesters at temperature, warm sludge flows through the process at 30 to 35 degrees C, and the administration block, lab and control buildings all need ventilation make-up air that […]
发电机与发动机排气热回收（空气－空气芯体）
Standby diesel and gas generators, and indeed any continuous industrial engine, convert only part of their fuel into electricity or shaft work; a large share leaves as hot exhaust, often 400 to 600 degrees C, and as jacket and coolant heat. For a generator set running even a few thousand hours a year, that exhaust […]
估算热回收投资回报：实用计算器演练
Before spending capital on an air-to-air heat recovery system, any serious buyer asks the same question: how long until it pays for itself? The answer is not a mystery and it does not need specialist software, a spreadsheet and a clear method give a defensible simple-payback number that survives scrutiny from finance and from the […]
EC 风机＋热回收：同时削减风机功率与采暖负荷
When engineers chase energy savings in a ventilation system, they usually think about the heat exchanger first and the fan second. That is backwards for part of the problem. A recovery core hands back the thermal energy in the exhaust, but the fan that pushes air through that core also consumes a large and often […]
Bakery & Oven Exhaust Heat Recovery: Taming Grease-Laden Hot Air
Walk into any commercial bakery and you feel it immediately: a wall of hot, greasy air pouring from the oven and proofer exhaust hoods, while the make-up air system fights to replace it with conditioned air pulled in from outside. That exhaust can leave at 150 to 250 degrees C carrying vaporised fat and flour […]
绕管式盘管系统：分离气流的设计规则
When the supply and exhaust ducts are in different parts of a building, or when you need absolute stream separation with no rotating parts, the run-around or coupled coil loop is often the only sensible recovery option. It uses two hydronic coils, one in the exhaust and one in the supply, joined by a pumped […]
寒冷气候下旋转式能量回收转轮的结霜与除霜策略
A rotary energy wheel is exceptionally effective at recovery, but in cold climates that same effectiveness becomes its weak point: the wheel constantly rotates the cold supply side through the warm, moisture-laden exhaust, and below freezing the exhaust condensate freezes onto the matrix and can block the duct. Understanding why wheels frost and how to […]
热管式换热器如何工作：无运动部件的被动式回收
A heat-pipe heat exchanger is the quiet workhorse of air-to-air recovery: it moves heat from one airstream to another with no fan, no pump and no moving parts inside the core, relying entirely on the physics of a two-phase refrigerant loop. That makes it uniquely suited to dirty, greasy or contamination-sensitive exhaust where you want […]