어느 공기 필터를 어디에: 산업 및 공간별 적용 가이드

Start With a Stage Strategy

Most systems run two stages: a cheap primary filter protects a finer final filter, cutting total cost. Clean spaces add a third (HEPA) stage.

Typical Arrangements by Space

Space / industry	Recommended stages	메모
Offices, schools, retail	G4 pre + F7 final	Comfort, moderate IAQ
Commercial HVAC (better IAQ)	G4 + F8/F9	Asthma/allergy, urban
Hospital wards	G4 + F8	Infection control
Operating theatres / isolation	G4 + F9 + H13/H14 terminal	ISO 5, laminar
Pharma / aseptic	G4 + F8 + H13/H14	ISO clean
Microelectronics cleanroom	G4 + F9 + H14 (+ U15)	Sub-micron control
Paint / spray booths	G3/G4 panel + F5-F7 pocket + carbon	Overspray + odour
Data centres	G4 pre + F9 final	Low ΔP priority
Food & beverage	G4 + F7/F8	Hygiene, washable frames
Compressor / turbine intake	G3/G4 + F6 pocket	Equipment protection

Quick Rules of Thumb

• Dirty, outdoor or process air first – a robust primary (G3/G4).
• People-sensitive spaces – at least F7 and a planned HEPA for critical zones.
• Odour or VOC complaint – add an activated-carbon stage after particulate filtration.
• Tight energy budget – favour low initial ΔP media and keep the primary stage healthy.

A simple way to apply the stage strategy is to think of filtration as a cost cascade: spending a little more on a robust primary stage almost always reduces the lifetime cost of the final filter, because the cheap media absorbs the bulk of the coarse load. In spaces with people but no special process risk, a two-stage G4 plus F7 or F8 arrangement is usually enough, while any area handling aseptic, electronic or painted product should add the appropriate third stage. Where odour or chemical complaints appear, the answer is rarely a denser particulate filter but a dedicated activated-carbon stage placed after the particulate bank. Keeping the primary stage healthy through planned changeout is also the single most effective way to hold down fan energy, since a loaded primary drives the whole bank toward its final pressure drop.

자주 묻는 질문

Why run two filter stages instead of one?
A cheap primary filter captures the coarse dust and protects the finer, more expensive final filter, which lowers the total cost of filtration across the system.

What filter arrangement suits an operating theatre?
Typically a G4 pre-filter, an F9 final filter and an H13 or H14 terminal HEPA to reach ISO 5 with laminar flow in critical zones.

How should odour or VOC complaints be handled?
Add an activated-carbon gas-phase stage after the particulate bank, because denser dust filters do not remove smells or volatile chemicals.

Which filtration is best for a data centre?
A G4 pre-filter plus an F9 final filter is common, with low pressure drop given priority to limit fan energy in always-on facilities.

자주 묻는 질문

Why run two filter stages instead of one?

A cheap primary filter captures the coarse dust and protects the finer, more expensive final filter, which lowers the total cost of filtration across the system.

What filter arrangement suits an operating theatre?

Typically a G4 pre-filter, an F9 final filter and an H13 or H14 terminal HEPA to reach ISO 5 with laminar flow in critical zones.

How should odour or VOC complaints be handled?

Add an activated-carbon gas-phase stage after the particulate bank, because denser dust filters do not remove smells or volatile chemicals.

Which filtration is best for a data centre?

A G4 pre-filter plus an F9 final filter is common, with low pressure drop given priority to limit fan energy in always-on facilities.